Ventamatic EC36D1 Manual Instrukcja Użytkownika

Przeglądaj online lub pobierz Instrukcja Użytkownika dla Wentylatory Ventamatic EC36D1 Manual. Ventamatic EC36D1 Manual User Manual Instrukcja obsługi

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 10
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 0
36” MaxxAir
Portable Evaporative Cooler
Owner’s Manual
File this owner’s manual in a safe place for future reference. It contains operating procedures – maintenance procedures –
trouble shooting guide – replacement parts guide – order form – and contact information. You will need this!
This Manual covers all of the following MaxxAir Portable Evaporative Coolers.
EC36D1 – MaxxAir 36” Direct Drive 1 Speed
Przeglądanie stron 0
1 2 3 4 5 6 7 8 9 10

Podsumowanie treści

Strona 1 - Owner’s Manual

36” MaxxAir Portable Evaporative Cooler Owner’s Manual File this owner’s manual in a safe place for future reference. It contains o

Strona 2 - Warnings and Cautions

10.0 Warranty LIMITED WARRANTY Ventamatic, Ltd. extends this warranty to the original retail purchaser of this fan against defec

Strona 3 - Table of Contents

Warnings and Cautions Read before operating your MaxxAir Portable Evaporative Cooler ELECTRICAL WARNING Do not use a 3 prong to 2 prong adapter

Strona 4 - 

MaxxAir Portable Evaporative Cooler Table of Contents 1.0 Introduction 1.1 Quick Start 1.2 Operate unit for 2 weeks before adding Evap-O-Matic

Strona 5 - 

MaxxAir Portable Evaporative Cooler 1.0 Introduction • Your MaxxAir was tested 3 ways. Your unit was tested for 1. Maximum air flow at operatin

Strona 6

 4.1 Connecting the electrical supply All MaxxAir models require regular 3 prongs, ground with 120 volt power supply. Plug electrical cord

Strona 7

open the valve to 1 ¼ turn. Allow water to run for 10 – 15 minutes on new cooling pads to totally saturate them with water. Once your units coolin

Strona 8

two bolts hold the metal angle retaining bar and the cooling pads in place. Next, remove the angle retaining bar and set to side. Now you are read

Strona 9 - Solution

7.5 MaxxAir Trouble Shooting Guide Problem 1. Water on the Floor A. Front of unit . . .

Strona 10

Problem (continued) 5. Scale build-up on cooling pads. Cause (continued) Hard water with excessive mineral content. Solution (continued) Use E

Komentarze do niniejszej Instrukcji

Brak uwag